Glossary
-
1D motion : One value from a source, such as the angle of one encoder or the reach of a crane arm. It drives a single field of a rig node (pan, tilt, roll, X, Y or Z).
-
Channel : One piece of data a source publishes, under a name such as
cartoni/1orsource/opentrackio/pose. Rig fields and the Lens page bind to channels. -
Edition : The firmware a unit runs: Standard, plus one tracking system for the other editions. See Editions.
-
Entrance pupil : The point of the lens the image is seen from, ahead of the Sensor plane. The 3D view starts the camera's view cone there, and OpenTrackIO carries its distance.
-
FIZ : Focus, Iris, Zoom: the raw positions of the three lens rings. FIZ alone says how far each ring has turned, not the focal length or the focus distance: a lens file turns it into those.
-
FreeD : FreeD D1, a long-established binary tracking protocol: the camera pose plus the raw zoom and focus encoders. See Lens pipeline & outputs.
-
Genlock : The studio's video reference signal (Black Burst or Tri-Level). Locked to it, RigFX sends one tracking frame per video frame, in step with the cameras and the render engine. See Genlock / Sync.
-
Lens file : A
.mrxlensfile made with CalibFX Lens: the calibration of one lens and camera, which turns FIZ into focal length, focus distance, distortion and the rest. See Lens. -
LTC : Linear timecode, the SMPTE 12M timecode carried on a BNC cable.
-
Node : One link of the rig chain: a position (X, Y, Z) and an orientation (pan, tilt, roll), each field fixed or bound to a channel. See Rig.
-
OpenTrackIO : The SMPTE RIS open tracking protocol (JSON over UDP): the camera pose plus the full calibrated lens. See opentrackio.org.
-
Phase offset : How long RigFX waits after each sync pulse before computing the frame. Source data that arrives before it is used for this frame, data after it one frame later. See Sync → Phase offset.
-
3D pose : A position and an orientation together. A source such as OpenTrackIO, FreeD or OptiTrack publishes a whole pose, which drives every field of a node at once.
-
Preset : A ready-made rig chain for a known piece of equipment, already bound to the right channels. See Rig presets.
-
Sensor offset : The last transform of the rig, from the last tracked axis to the camera's Sensor plane. See Rig → Sensor Offset.
-
Sensor plane : Where the image forms in the camera, marked on the side of camera bodies with a circle crossed by a line. The rig chain ends there.
-
Studio offset : The first transform of the rig: where the rig stands relative to the zero of the studio. See Rig → Studio Offset.
-
Sync card : The board inside RigFX that reads the genlock, the timecode and the lens.