Get started
From RigFX hardware to a tracked camera in the render engine, in seven steps. Each step links to the page with the details. For a complete example on real equipment, follow a tutorial.
1. Connect RigFX
- Power: 12 V DC on the XLR 4-pin connector (Power).
- Network: the studio switch, with the render engine and the computer that will open the web app (Network).
- Genlock: the studio reference on Ref, and the studio timecode on Timecode if you have one, from the same sync generator (Genlock / Sync).
- Tracking and lens: the lens cable, the Cartoni encoders, or the network sources of your edition.
The Power LED blinks fast for a few seconds, then slowly: the unit runs and its network link is up (LED indicators).
2. Open the web app
Find the unit with RigFX Network Discovery, give it an address on your network, then click Webapp (First connection). Out of the box the unit is at http://192.168.37.50.
Settings are saved on the unit as you change them (System).
3. Sync
Settings → Sync: Sync mode External, Target framerate the studio's rate. The card reads Locked (Sync). Without a sync generator, choose Freerun.
4. Sources
Settings → Source: enable the inputs you use and point each sender at the unit's address and the port on its card. Each card turns Connected (Source). With the Cartoni firmware, zero the encoders with Set 0 at their reference position.
5. Rig
Settings → Rig: click Presets and load the one that matches your equipment, then enter the dimensions it asks for on the node cards (Rig, Measuring your rig). Move the rig: the 3D view must follow. Without a matching preset, build the chain with + Add Node.
6. Lens
Settings → Lens: pick where the lens data comes from (Lens):
- a FIZ source alone for a FreeD output: the render engine applies its own lens file;
- a FIZ source and a lens file for an OpenTrackIO11 output;
- a Lens Source (OpenTrackIO11, Canon CV) when the camera sends its calibrated lens.
Lens pipeline explains the three cases.
7. Output
Settings → Output: on one destination, choose FreeD6 or OpenTrackIO11, the render engine's IP and Port, and Enable it (Output). The render engine now receives one packet per video frame.
To place the rig precisely in the studio, line it up with CalibFX Lineup: tick Chain transforms on an OpenTrackIO11 output.
Tutorials
- Cartoni: Tripod + e-Sensor
- Cartoni: e-Jibo + e-Sensor
- Cartoni: e-Jibo + FR7 underslung
- OptiTrack: CinePuck on camera
Something not working? See Troubleshooting.