Power
12 V DC supply voltage
0.3 A minimum supply current (3.6 W)
XLR 4-pin on the network and power panel
RigFX runs on 12 V DC through the XLR 4-pin connector on the network and power panel (Hardware overview). Use the power supply shipped with the unit, or any 12 V DC supply that gives at least 0.3 A.
Pinout
The standard 4-pin XLR power convention:
| Pin | Signal |
|---|---|
| 1 | Ground |
| 4 | +12 V |
| 2, 3 | Not connected |
On camera
Power RigFX from the camera's D-Tap port with a D-Tap to XLR 4-pin cable.
At power-on
The Power LED blinks fast while the unit boots (under 5 seconds), then settles into a slow heartbeat once it runs with its network link up: see LED indicators.